Results ================================= #. From the Windows 10 Jumpbox command prompt type "dig www.f5demo.com" Repeat the command several times to see that the name resolution is alternating between 10.1.10.51 and 10.1.60.51. .. image:: /_static/class1/dc01_new_delegation_create_cname_results.png :width: 800 #. Observe Wide-IP statistics on dns.sitea: **Statistics ›› Module Statistics : DNS : GSLB ›› Wide IPs : www.wip.f5demo.com : A** (Note: The images show the Wide-IP as www.f5demo.com but you will have www.wip.f5demo.com in the lab. The TMSH commands reference the correct Wide-IP name) .. image:: /_static/class1/gtm1_site1_wideip_statistics_flyout.png :width: 800 .. image:: /_static/class1/gtm1_site1_wideip_statistics_detail.png :width: 800 .. admonition:: TMSH tmsh show gtm wideip a www.wip.f5demo.com #. Observe Wide-IP statistics on dns.siteb: **Statistics ›› Module Statistics : DNS : GSLB ›› Wide IPs : www.wip.f5demo.com : A** #. Disable physical interfaces on dns.siteb: .. image:: /_static/class1/gtm1_site1_disable_interfaces.png :width: 800 .. admonition:: TMSH tmsh modify net interface all disabled #. Refresh statistics on dns.sitea and make sure DNS requests are still resolving. #. Re-enable interfaces on dns.siteb, disable interfaces on dns.sitea. Observe statistics on dns.siteb and make sure DNS requests are still resolving. .. admonition:: TMSH tmsh modify net interface all enabled #. Observe pool statistics on dns.siteb: **Statistics ›› Module Statistics : DNS : GSLB ›› Pools : www.f5demo.com_pool : A** .. image:: /_static/class1/results_pool_statistics.png :width: 800 .. admonition:: TMSH show gtm pool a www.f5demo.com_pool #. Re-enable interfaces on dns.sitea .. admonition:: TMSH tmsh modify net interface all enabled #. Using Putty on the Jumpbox, ssh into dns.sitea and run the following command to watch logs (use password 'F5demo!!' if prompted: .. admonition:: TMSH tail -f /var/log/ltm