Verify Configuration ================================================================================ If disconnected from the BIG-IP (SSL Orchestrator) TMUI, reconnect to: **https://**. Login using the credentials provided earlier. Review LTM Pool -------------------------------------------------------------------------------- Navigate to **Local Traffic > Pools**. Confirm that the **webapp** pool was created. Review SSL Orchestrator Topology -------------------------------------------------------------------------------- Navigate to **SSL Orchestrator > Configuration**. .. image:: ./images/ansible-sslo-1.png :align: left Confirm that the **sslo_l3inboundapp** Topology was created. Review SSL Orchestrator Interception Rule -------------------------------------------------------------------------------- Click on the **Interception Rules** tab. .. image:: ./images/ansible-sslo-2.png :align: left Confirm that the **sslo_l3inboundapp** Interception Rule was created. Review SSL Orchestrator Services -------------------------------------------------------------------------------- Click on the **Services** tab. .. image:: ./images/ansible-sslo-3.png :align: left Confirm that the **ssloS_SNORT1** and **ssloS_SNORT2** Services were created. Review SSL Orchestrator Service Chains -------------------------------------------------------------------------------- Click on the **Services** tab. .. image:: ./images/ansible-sslo-4.png :align: left Confirm that the **ssloSC_service_chain_1** and **ssloSC_service_chain_2** Service Chains were created. Review SSL Orchestrator Security Policy -------------------------------------------------------------------------------- Click on the **Security Policies** tab. .. image:: ./images/ansible-sslo-5.png :align: left Confirm that the **ssloP_sslopolicy** Security Policy was created. Review SSL Orchestrator SSL Configuration -------------------------------------------------------------------------------- Click on the **SSL Configurations** tab. .. image:: ./images/ansible-sslo-6.png :align: left Confirm that the **ssloT_ssloconfig** SSL Configuration was created. | .. note:: If you click on some of the individual components (for example, Services), you will see a red banner stating the configuration is in read-only mode. This is because the configuration was created outside of the SSL Orchestrator Guided Configuration UI.