cm watch-sys-device
cm watch-sys-device(1) BIG-IP TMSH Manual cm watch-sys-device(1)
NAME
watch-sys-device - Displays information about the local device.
MODULE
cm
SYNTAX
Run the watch-sys-device program within the cm module using the syntax shown in the following sections.
RUN
run watch-sys-device
DESCRIPTION
You can use the watch-sys-device program to view dynamic information about the local device.
By default, multiple devices with identical information are collapsed into a single row that displays in green. The devices
column identifies the devices by the suffix of the configuration synchronization IP address configured on the device. For
example, if the devices in a device group have the IP addresses 10.0.0.15 and 10.0.0.16, the IDs in this column will be 15
and 16. Use the c (collapse) command to deactivate/activate this behavior.
Within the program, you can use the following keys:
Press h to see a list of available commands.
Press the back tick key (`) to exit the help page.
Press c to toggle the view from a collapsed view to a full view. The command gathers information from every device in the
trust group. When all devices in the trust group report the same information the view is collapsed and one line,
highlighted in green, displays the information. The devices included in the line are shown in the devices column. You can
press c to see the full view, which displays each device on a separate line.
Press Ctrl-C to exit the program.
Press the arrow keys to navigate across the columns or down the rows.
The content in the columns includes:
devices
Displays the suffix of the configuration synchronization IP address configured on the device. For example, if the
devices in a device group have the IP addresses 10.0.0.15 and 10.0.0.16, the IDs in this column will be 15 and 16.
name Displays the device object name.
platform
Displays the device platform.
build
Displays the software build installed on the device.
failover_state
Displays the high availability state (active or standby) of the device.
mgmt_ip
Displays the IP address of the management port on the device.
configsync_ip
Displays the IP address on the device that is used for configuration synchronization.
unicast_ip
Displays the unicast IP address of the device.
multicast_ip
Displays the multicast IP address of the device.
mirror_ip
Displays the IP address used for configuration mirroring for the device.
mirror_secondary_ip
Displays the secondary IP address used for configuration mirroring for the device.
desc Displays a description of the device.
SEE ALSO
run, tmsh, watch-devicegroup-device, watch-trafficgroup-device
COPYRIGHT
No part of this program may be reproduced or transmitted in any form or by any means, electronic or mechanical, including
photocopying, recording, or information storage and retrieval systems, for any purpose other than the purchaser's personal
use, without the express written permission of F5 Networks, Inc.
F5 Networks and BIG-IP (c) Copyright 2008-2013, 2016. All rights reserved.
BIG-IP 2017-06-30 cm watch-sys-device(1)