ltm message-routing generic route
ltm message-routing generic route(1) BIG-IP TMSH Manual ltm message-routing generic route(1)
NAME
route - Configures a static route the generic message parser uses to route generic message protocol messages.
MODULE
ltm message-routing generic
SYNTAX
Configure the route component within the ltm message-routing generic module using the syntax shown in the following
sections.
CREATE/MODIFY
create route [name]
modify route [name]
options:
app-service [[string] | none]
description [string]
destination-address [string]
peer-selection-mode [ sequential | ratio ]
peers { [peer-name] }
source-address [string]
edit route [ [ [name] | [glob] | [regex] ] ... ]
options:
all-properties
non-default-properties
reset-stats route
reset-stats route [ [ [name] | [glob] | [regex] ] ... ]
DISPLAY
list route
list route [ [ [name] | [glob] | [regex] ] ... ]
DELETE
delete route [name]
DESCRIPTION
You can use the route component to manage a generic message static route.
EXAMPLES
create route my_route
Creates a static route named my_route that uses a wildcard value for the source-address and destination-address parameters.
This acts as a default route.
create route my_route { destination-address helpdesk peers add { peer1 peer2 }
Creates a static route named my_route that contains two peers, peer1 and peer2. Messages routed with a destination-address
of helpdesk are routed to a pool member contained in peer1 or peer2, based on the specified peer-selection-mode.
OPTIONS
app-service
Specifies the name of the application service to which the object belongs. The default value is none. Note: If the
strict-updates option is enabled on the application service that owns the object, you cannot modify or delete the
object. Only the application service can modify or delete the object.
destination-address
Specifies the destination address of the route. If this parameter is not present, the generic message parser considers
the destination-address as a wildcard that matches all message destination addresses. The default value is none.
description
User defined description.
peer-selection-mode
Specifies the method the generic message parser uses to select a peer from the specified list of peers. The default
value is sequential.
sequential
Specifies that the generic message parser selects the first peer in the list of peers. If the protocol
retransmits the message, the generic message parser uses another pool member in the first peer. If all pool
members in a peer are unavailable, the generic message parser uses the next peer in the list.
ratio
Specifies that the generic message parser selects a peer from a list of peers based on the relative ratio values
of each peer. For example if three peers have ratios of 1, 1, and 2, the first 2 peers have a 25% (1/4)
probability of being selected and the third peer has a 50% (2/4) probability of being selected.
peers
Specifies a list of peers.
source-address
Specifies the source address of the route. If this parameter is not present, the generic message parser considers the
source-address as a wildcard that matches all message sources addresses. The default value is none.
SEE ALSO
create, delete, edit, glob, list, ltm virtual, modify, regex, reset-stats, tmsh, ltm message-routing generic peer ltm
message-routing generic router
COPYRIGHT
No part of this program may be reproduced or transmitted in any form or by any means, electronic or mechanical, including
photocopying, recording, or information storage and retrieval systems, for any purpose other than the purchaser's personal
use, without the express written permission of F5 Networks, Inc.
F5 Networks and BIG-IP (c) Copyright 2012-2014. All rights reserved.
BIG-IP 2017-03-15 ltm message-routing generic route(1)