ltm rule command LSN inbound-entry
iRule(1) BIG-IP TMSH Manual iRule(1)
LSN::inbound-entry
LSN::inbound-entry
SYNOPSIS
LSN::inbound-entry (get | delete) IP_TUPLE IP_PROTOCOL
LSN::inbound-entry create (-mirror)?
(-override)?
(-dslite DSLITE_LOCAL_ADDR DSLITE_REMOTE_ADDR)?
(-prefix IP_ADDR)?
LSN_POOL
TIMEOUT
CLIENT_TUPLE
TRANSLATION_TUPLE
IP_PROTOCOL
DESCRIPTION
This command creates and gets the inbound mapping for a translation address, translation port and protocol.
LSN::inbound-entry get : LSN::inbound-entry create [-mirror] [-override]
[-dslite ] [-prefix ]
v11.5+ LSN::inbound-entry delete :
RETURN VALUE
LSN::inbound-entry get :
- Gets inbound entry for the specified translation IP, translation port and protocol. Protocol can be set TCP or UDP.
This command returns the client IP address, port and route domain ID.
LSN::inbound-entry create [-mirror] [-override] [-dslite ] [-prefix ]
- Creates an inbound mapping to the client IP address and port. The "-mirror" options can be used for mirroring inbound
connections. The "-override" option may be used to update a mapping. Otherwise, the mapping is not saved if a matching
entry for the specified translation address and port already exists. For a dslite client "-dslite" option should be used to
specify the dslite tunnel details. For a NAT64 client the "-prefix" option should be used to specify the IPv6 prefix used
to translate extern IPv4 host addresses to IPv6 addresses. The translation address may be unspecified (0.0.0.0) and/or the
translation port may be unspecified (0). A suitable address and/or port will be picked. The specified translation address
must be in the LSN pool member list and the specified port must be within the translation port range. In Deterministic mode
the specified translation address and port must match the deterministic mapping for the client. In PBA mode the specified
translation address and port must not belong to a port block of a different client. A new port block will be allocated if
the client block limit permits and the specified translation address and port do belong to an existing port block. The
XtimeoutX specifies the idle timeout for the entry. The "protocol" specifies the protocol an external client will use to
connect to the client IP/port behind LSN. This command returns the translation IP address, port and route domain ID.
LSN::inbound-entry delete :
- Deletes an inbound mapping for the specified translation address, port, and protocol.
VALID DURING
ALL
EXAMPLES
HINTS
SEE ALSO
CHANGE LOG
@BIGIP-11.3.0
- Initial version where the command was introduced
BIG-IP 2022-04-12 iRule(1)