sys cluster
sys cluster(1) BIG-IP TMSH Manual sys cluster(1)
NAME
cluster - Configures a cluster in a VIPRION(r) system.
MODULE
sys
SYNTAX
Configure the cluster component within the sys module using the syntax
in the following sections.
MODIFY
modify cluster [name]
options:
address [IP address | none]
members {
[1 | 2 | 3 | 4] {
options:
address [IP address | none]
[disabled | enabled]
priming [disabled | enabled]
}
}
min-up-members [integer]
min-up-members-enabled [no | yes]
edit cluster default
options:
all-properties
non-default-properties
DISPLAY
list cluster
options:
all-properties
non-default-properties
one-line
show running-config cluster
show running-config cluster [option name]
options:
one-line
show cluster
show cluster [option name]
options:
all-properties
field-fmt
DESCRIPTION
You can use the cluster component to modify the configuration of the
primary blade in a cluster. When you do this, the system automatically
propagates the changes to the other blades in the cluster. This is
known as cluster synchronization.
EXAMPLES
modify cluster default address 192.168.217.44/24
Sets the floating management IP address for the cluster default to an
IP address of 192.168.217.44.
list cluster my_cluster
Displays the properties of the cluster named my_cluster.
OPTIONS
address
Specifies an IP address for the cluster or cluster member. The
default value is none.
disabled
Disables the specified cluster member. The default value is
enabled.
enabled
Enables the specified cluster member. This is the default value.
members
Specifies the cluster members to be acted on by the command. A
cluster member is a slot into which you insert a blade. The
cluster member is identified by the number assigned to the slot.
min-up-members
Specifies the minimum number of cluster members that must be up
for the cluster to remain Active. The default value is 0.
min-up-members-enabled
When set to yes, specifies that when the number of cluster members
that are active is below the value of the option min-upmembers,
the cluster fails over to its peer. The default value is no.
Enable this parameter when you configure a redundant pair.
Important: Make sure that you modify the value of the min-up-
members option appropriately when you take blades down in a
cluster. Otherwise, you can get into the condition where disabling
a cluster member brings the cluster below the value of the option
min-up-members, which can cause the cluster to fail over to its
peer.
name
Specifies a name for the cluster. This option is required.
priming
Prevents a cluster member from proceeding to the RUNNING cluster
quorum state, which is useful when a blade is in a reboot loop.
The default value is disabled.
SEE ALSO
edit, list, modify, show, tmsh
COPYRIGHT
No part of this program may be reproduced or transmitted in any form or
by any means, electronic or mechanical, including photocopying,
recording, or information storage and retrieval systems, for any
purpose other than the purchaser's personal use, without the express
written permission of F5 Networks, Inc.
F5 Networks and BIG-IP (c) Copyright 2009-2013. All rights reserved.
BIG-IP 2015-06-29 sys cluster(1)