sys geoip
sys geoip(1) BIG-IP TMSH Manual sys geoip(1)
NAME
geoip - Loads the GeoIP data files.
MODULE
sys
SYNTAX
Use the geoip component within the gtm module to load the GeoIP data
files using the syntax in the following sections.
LOADING
load geoip
DESCRIPTION
The BIG-IP system ships with three default database files that are
stored in the /usr/share/GeoIP/v2 directory. The three files are:
F5GeoIP.dat, F5GeoIPISP.dat, and F5GeoIPv6.dat.
You can download and install updated GeoIP database files using the
procedure available from the F5 download site. The installation places
the updated database files in the share/GeoIP/v2 directory.
When you run the load geoip command sequence, the system loads the
GeoIP files from disk into the running configuration. If you have
downloaded and installed updated database files, those files are loaded
from the /shared/GeoIP/v2 directory. Otherwise, the default database
files are loaded from the /usr/share/GeoIP/v2 directory. Note that if
both directories contain the same files, the files in shared/GeoIP/v2
are loaded.
EXAMPLES
load geoip
Loads the GeoIP files from disk into the running configuration.
SEE ALSO
load, tmsh
COPYRIGHT
No part of this program may be reproduced or transmitted in any form or
by any means, electronic or mechanical, including photocopying,
recording, or information storage and retrieval systems, for any
purpose other than the purchaser's personal use, without the express
written permission of F5 Networks, Inc.
F5 Networks and BIG-IP (c) Copyright 2009-2012. All rights reserved.
BIG-IP 2015-09-21 sys geoip(1)