wom endpoint-discovery
wom endpoint-discovery(1) BIG-IP TMSH Manual wom endpoint-discovery(1)
NAME
endpoint-discovery - Configures automatic discovery of remote endpoints
for WAN optimization.
MODULE
wom
SYNTAX
Configure the endpoint-discovery component with the wom module using
the syntax in the following sections.
MODIFY
modify endpoint-discovery
options:
auto-save [disabled | enabled]
description [string]
discoverable [disabled | enabled]
discovered-endpoint [disabled | enabled]
icmp-max-requests [integer]
icmp-min-backoff [integer]
icmp-num-retries [integer]
max-endpoint-count [integer]
mode [disable | enable-all | enable-icmp | enable-tcp]
reset-stats endpoint-discovery
DISPLAY
list endpoint-discovery
show running-config endpoint-discovery
options:
all-properties
non-default-properties
one-line
show endpoint-discovery
options:
(default | exa | gig | kil | meg | peta | raw | tera | yotta | zetta)
DESCRIPTION
You can use the endpoint-discovery component to specify parameters for
automatically discovering remote endpoints for WAN optimization. These
endpoints are configured WAN Optimization Managers on remote BIG-IP(r)
systems that advertise themselves to the configured WAN Optimization
Manager on the local BIG-IP system.
EXAMPLES
modify endpoint-discovery max-endpoint-count 10
Limits the number of remote endpoints that can be discovered to
ten. After discovering ten remote endpoints, the WOM stops sending
probe messages.
list endpoint-discovery all-properties
Displays the configuration parameters for the discovery of remote
endpoints.
OPTIONS
auto-save
Specifies whether the system automatically saves remote endpoints
that it discovers. The default value is enabled.
description
User defined description.
discoverable
Specifies whether the WAN Optimization Manager responds to probe
messages it receives from WAN Optimization Managers on remote BIG-
IP systems. The default value is enabled.
discovered-endpoint
Specifies whether the WAN Optimization Manager sends out probe
messages to discover other WAN Optimization Managers on remote
BIG-IP systems in the network. The default value is enabled.
icmp-max-requests
Specifies the maximum number of ICMP probe message requests, after
which the system stops sending probe message requests until at
least one message is cleared from the queue by either a timeout or
a response. The default value is 1024.
icmp-min-backoff
Specifies the maximum number of seconds to wait before abandoning
an ICMP probe message request and resending it. The range is from
0 to 255. The default value is 5.
icmp-num-retries
Specifies the maximum number of times the system sends an ICMP
probe message request for a single flow. The range is from 0 to
255. The default value is 10.
max-endpoint-count
Specifies the highest number of endpoints for the system to
discover before it stops sending probe messages. The range is from
0 to 255. The default value is 0, which indicates no limit.
mode Specifies the type of probe messages the system should send. The
default value is enable-all.
The options are:
disable
Turns off probe messages.
enable-icmp
Sends only ICMP probe messages.
enable-tcp
Sends only TCP probe messages.
enable-all
Sends both ICMP and TCP probe messages.
SEE ALSO
list, modify, show, tmsh, wom local-endpoint, wom remote-endpoint, wom
server-discovery
COPYRIGHT
No part of this program may be reproduced or transmitted in any form or
by any means, electronic or mechanical, including photocopying,
recording, or information storage and retrieval systems, for any
purpose other than the purchaser's personal use, without the express
written permission of F5 Networks, Inc.
F5 Networks and BIG-IP (c) Copyright 2009-2012. All rights reserved.
BIG-IP 2012-04-10 wom endpoint-discovery(1)