cli global-settings

cli global-settings(1)	      BIG-IP TMSH Manual	cli global-settings(1)



NAME
       global-settings - Configures settings for tmsh

MODULE
       cli

SYNTAX
       Configure the global-settings component within the cli module using the
       syntax shown in the following sections.

   MODIFY
	edit global-settings
	  options:
	    all-properties
	    non-default-properties

	modify global-settings
	  options:
	    audit [disabled | enabled]
	    description [string]
	    idle-timeout [disabled | integer]
	    scf-backup-number [integer]
	    service [number | name]

   DISPLAY
	list global-settings
	list global-settings [option]
	  options:
	    all-properties
	    non-default-properties
	    one-line

   DELETE
       You cannot delete the default global settings.

DESCRIPTION
       You can use the global-settings component to configure multiple
       settings for tmsh.

EXAMPLES
       modify global-settings audit enabled

       Enables auditing for tmsh.

       modify global-settings idle-timeout 15

       Sets the user idle timeout from tmsh to 15 minutes.

OPTIONS
       audit
	    Specifies the global audit level for tmsh. The audited commands
	    are stored in /var/log/audit. The default value is enabled. The
	    audit levels are:

	    disabled
		 tmsh does not log commands that users enter.

	    enabled
		 tmsh audits only commands that users enter. Note that the
		 system does not audit the commands that the command load
		 runs.

       description
	    User defined description.

       idle-timeout
	    If not disabled, log a user in tmsh interactive mode out
	    automatically after a specified set of minutes. An administrator
	    may change the timeout value at any time and the new policy will
	    take place immediately.

       scf-backup-number
	    Specifies the number of backup single configuration files that the
	    system stores when you enter the following command sequence in
	    tmsh:

	    load sys config file

	    When you run the command, the system saves the single
	    configuration file. By default, the system saves two backup single
	    configuration files. For example, if you set the scf-backup-number
	    option to 3, after you run the command sequence tmsh load sys
	    config file for the third time, the system has three versions of
	    the single configuration file: /var/local/scf/backup.scf,
	    /var/local/scf/backup-1.scf, and /var/local/scf/backup-2.scf. The
	    newest file is /var/local/scf/backup.scf.

       service
	    Specifies the format in which tmsh displays a service. The default
	    value is name. The options are:

	    name Displays a service using a protocol name, for example, http.

	    number
		 Displays a service using a numeric value, for example,
		 192.168.10.20:80, where 80 indicates http.

SEE ALSO
       edit, list, modify, run, tmsh

COPYRIGHT
       No part of this program may be reproduced or transmitted in any form or
       by any means, electronic or mechanical, including photocopying,
       recording, or information storage and retrieval systems, for any
       purpose other than the purchaser's personal use, without the express
       written permission of F5 Networks, Inc.

       F5 Networks and BIG-IP (c) Copyright 2009-2013, 2016 All rights
       reserved.



BIG-IP				  2016-03-14		cli global-settings(1)