ltm rule command LSN inbound-entry
iRule(1) BIG-IP TMSH Manual iRule(1)
LSN::inbound-entry
LSN::inbound-entry
SYNOPSIS
LSN::inbound-entry (get | delete) IP_TUPLE IP_PROTOCOL
LSN::inbound-entry create (-mirror)?
(-override)?
(-dslite DSLITE_LOCAL_ADDR
DSLITE_REMOTE_ADDR)?
(-prefix IP_ADDR)?
LSN_POOL
TIMEOUT
CLIENT_TUPLE
TRANSLATION_TUPLE
IP_PROTOCOL
DESCRIPTION
This command creates and gets the inbound mapping for a translation
address, translation port and protocol.
LSN::inbound-entry get :
LSN::inbound-entry create [-mirror] [-override] [-dslite
] [-prefix ]
v11.5+ LSN::inbound-entry delete
:
RETURN VALUE
LSN::inbound-entry get :
- Gets inbound entry for the specified translation IP, translation
port and protocol. Protocol can be set TCP or UDP. This command returns
the client IP address, port and route domain ID.
LSN::inbound-entry create [-mirror] [-override] [-dslite ] [-prefix ]
- Creates an inbound mapping to the client IP address and port. The
"-mirror" options can be used for mirroring inbound connections. The
"-override" option may be used to update a mapping. Otherwise, the
mapping is not saved if a matching entry for the specified translation
address and port already exists. For a dslite client "-dslite" option
should be used to specify the dslite tunnel details. For a NAT64 client
the "-prefix" option should be used to specify the IPv6 prefix used to
translate extern IPv4 host addresses to IPv6 addresses. The translation
address may be unspecified (0.0.0.0) and/or the translation port may be
unspecified (0). A suitable address and/or port will be picked. The
specified translation address must be in the LSN pool member list and
the specified port must be within the translation port range. In
Deterministic mode the specified translation address and port must
match the deterministic mapping for the client. In PBA mode the
specified translation address and port must not belong to a port block
of a different client. A new port block will be allocated if the client
block limit permits and the specified translation address and port do
belong to an existing port block. The XtimeoutX specifies the idle
timeout for the entry. The "protocol" specifies the protocol an
external client will use to connect to the client IP/port behind LSN.
This command returns the translation IP address, port and route domain
ID.
LSN::inbound-entry delete :
- Deletes an inbound mapping for the specified translation address,
port, and protocol.
VALID DURING
ALL
EXAMPLES
HINTS
SEE ALSO
CHANGE LOG
@BIGIP-11.3.0
- Initial version where the command was introduced
BIG-IP 2019-05-10 iRule(1)