gtm monitor none¶

gtm monitor none(1) BIG-IP TMSH Manual gtm monitor none(1)

NAME
none - A base level NULL monitor used to indicate that no monitoring will be performed.

MODULE
gtm monitor

SYNTAX
The none component within the gtm monitor module can be used only with the syntax described in the following
sections.

DISPLAY
list none
list none [ [ [name] | [glob] | [regex] ] ... ]
show running-config none
show running-config none [ [ [name] | [glob] | [regex] ] ... ]
options:
all-properties
non-default-properties
one-line
partition

CREATE/MODIFY/DELETE
Note: You cannot create a custom monitor based off of the none monitor nor can you modify or delete the
existing default none monitor.

DESCRIPTION
The none component is used to configure a GTM pool member that explicitly does not inherit its parent pool's
monitor and remains un-monitored, regardless of the monitor setting on the parent pool.

EXAMPLES
create gtm pool a test_pool monitor http members add { test:vs_1 { monitor none } test:vs_2 { } }

Creates a gtm pool with an http monitor that has two members, vs_1 and vs_2. The pool member vs_1 is
configured with the none monitor so it does not inherit http monitoring from its parent pool, whereas pool
member vs_2 will inherit and use its parent's http monitor.

OPTIONS
Note: While the following options are specified as part of the definition of the none monitor, they cannot be
changed since the none monitor is used to define the absence of a monitor, not an actual monitor.

app-service
Displays the application service to which the object belongs. The permanent value is none. Note:
Regardless if the strict-updates option is enabled, you cannot modify or delete the object; these are
unavailable options for the none monitor.

defaults-from
Specifies the name of the monitor from which this monitor inherits settings. The default value is none.

destination
Specifies the IP address and service port of the resource that is the destination of this monitor. The
default value is *:6666, also shown as *:ircu-2.

ignore-down-response
Specifies whether this monitor ignores a down response from the system it is monitoring. The default
value is disabled.

interval
Specifies the frequency at which the system issues the monitor check. The default value is 0 seconds.

partition
Displays the administrative partition within which the component resides. The default value is Common.

probe-timeout
Specifies the number of seconds after which the BIG-IP(r) system times out the probe request to the BIG-
IP system. The default value is 0 seconds.

time-until-up
Specifies the amount of time in seconds after the first successful response before a node is marked up. A
value of 0 causes a node to be marked up immediately after a valid response is received from the node.
The default value is 86500.

timeout
Specifies the number of seconds the target has in which to respond to the monitor request. The default
value is 0 seconds.

up-interval
Specifies, in seconds, the frequency at which the system issues the monitor check when the resource is
up. The default value is 0, which specifies that the system uses the value of the interval option whether
the resource is up or down.