sys db
sys db(1) BIG-IP TMSH Manual sys db(1)
NAME
db - Displays or modifies bigdb database entries.
MODULE
sys
SYNTAX
Configure the db component within the sys module using the syntax in the following sections.
MODIFY
modify db [name] value [database variable value]
modify db [name] reset-to-default
DISPLAY
list db
list db [ [ [name] | [glob] | [regex] ] ...]
options:
all-properties
default-value
non-default-properties
one-line
value
value-range
show running-config db
show running-config db [ [ [name] | [glob] | [regex] ] ...]
options:
all-properties
DESCRIPTION
You can use the db component to modify and retrieve the data that is stored in the bigdb configuration
database.
Important: After you change a bigdb database variable using the db component, you must run the command
sequence save config. If you do not, the next time that you run the command sequence load [config base |
config], the value of the bigdb database variable may be reset to the value in the stored configuration.
Note that tmsh only displays bigdb database entries when you explicitly request them.
EXAMPLES
modify db Connection.SynCookies.Threshold value 16384
Sets the database entry, SYN Check(tm) Activation Threshold, to the given value.
modify db Connection.SynCookies.Threshold reset-to-default
Sets the database entry, SYN Check(tm) Activation Threshold, back to the default value.
list log.mcpd.level
Displays the properties of the database entry log.mcpd.level:
OPTIONS
default-value
Displays the system-supplied default value of the database entry.
glob Displays the items that match the glob expression. See help glob for a description of glob expression
syntax.
name Specifies the unique name of the database variable. This option is required for the command modify.
regex
Displays the items that match the regular expression. The regular expression must be preceded by an at
sign (@[regular expression]) to indicate that the identifier is a regular expression. See help regex for
a description of regular expression syntax.
reset-to-default
Resets the database variable back to its default value.
value
Specifies the value to which you want to set the specified database entry.
value-range
Displays the type of data that you can use with the value option. The options are:
integer
IP address
list of valid values
management IP address
string
unsigned integer
SEE ALSO
glob, list, modify, regex, show, tmsh
COPYRIGHT
No part of this program may be reproduced or transmitted in any form or by any means, electronic or
mechanical, including photocopying, recording, or information storage and retrieval systems, for any purpose
other than the purchaser's personal use, without the express written permission of F5 Networks, Inc.
F5 Networks and BIG-IP (c) Copyright 2008-2010. All rights reserved.
BIG-IP 2011-08-05 sys db(1)