sys geoip
sys geoip(1) BIG-IP TMSH Manual sys geoip(1)
NAME
geoip - Loads the GeoIP data files.
MODULE
sys
SYNTAX
Use the geoip component within the gtm module to load the GeoIP data files using the syntax in the following
sections.
LOADING
load geoip
DESCRIPTION
The BIG-IP system ships with three default database files that are stored in the /usr/share/GeoIP/v2
directory. The three files are: F5GeoIP.dat, F5GeoIPISP.dat, and F5GeoIPv6.dat.
You can download and install updated GeoIP database files using the procedure available from the F5 download
site. The installation places the updated database files in the share/GeoIP/v2 directory.
When you run the load geoip command sequence, the system loads the GeoIP files from disk into the running
configuration. If you have downloaded and installed updated database files, those files are loaded from the
/shared/GeoIP/v2 directory. Otherwise, the default database files are loaded from the /usr/share/GeoIP/v2
directory. Note that if both directories contain the same files, the files in shared/GeoIP/v2 are loaded.
EXAMPLES
load geoip
Loads the GeoIP files from disk into the running configuration.
SEE ALSO
load, tmsh
COPYRIGHT
No part of this program may be reproduced or transmitted in any form or by any means, electronic or
mechanical, including photocopying, recording, or information storage and retrieval systems, for any purpose
other than the purchaser's personal use, without the express written permission of F5 Networks, Inc.
F5 Networks and BIG-IP (c) Copyright 2009-2012. All rights reserved.
BIG-IP 2015-09-21 sys geoip(1)